| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Drivetrain | Section: Axle/Differential | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002OTR005X |
| Title: AXLE AND DIFFERENTIAL: REAR AXLE HUB: ON-VEHICLE INSPECTION (2008 Sequoia) | ||
ON-VEHICLE INSPECTION
1. REMOVE PARKING BRAKE ASSEMBLY
2. INSPECT REAR AXLE HUB BEARING LOOSENESS
|
(a) Using a dial indicator, check for looseness near the center of the axle hub. Maximum: 0.05 mm (0.00197 in.) NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface. If the looseness exceeds the maximum, replace the axle hub. |
3. INSPECT REAR AXLE HUB RUNOUT
|
(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt. Maximum: 0.05 mm (0.0020 in.) NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface. If the runout exceeds the maximum, replace the axle hub. |
4. INSTALL PARKING BRAKE ASSEMBLY
|
|